Armacost Lighting 840450 für LED-Beleuchtung, mit abnehmbarem Netzkabel, 45 Watt, weiße 45-Watt-12-Volt-Beleuchtung

Name: Armacost Lighting 840450 für LED-Beleuchtung, mit abnehmbarem Netzkabel, 45 Watt, weiße 45-Watt-12-Volt-Beleuchtung
Brand: Armacost Lighting
SKU: 0856944003962
Price: 95.81 EUR
Availability: InStock

Brand:Armacost Lighting

3.7/5

€
95.81

Der dimmbare 45-Watt-LED-Treiber von Arm Cost Lighting bietet eine hervorragende LED-Dimmleistung und eine Helligkeitssteuerung in architektonischer Qualität. Obwohl praktisch alle Dimmer mit diesem dimmbaren LED-Treiber funktionieren, empfiehlt Arm Cost Lighting aufgrund ihres niedrigen Dimmbereichs die Universaldimmer von Lutron CFL und Leviton illumatech. Bietet sanftes, stabiles und flimmerfreies Dimmen mit Sanftanlauf und der gewünschten Ein- und Ausblendleistung. Wenn ein Dimmer auf volle Helligkeit eingestellt ist, liefert der LED-Treiber die volle Helligkeit – es gibt keinen Verlust an erstklassiger Lichtleistung. Der Direktdrahttreiber verfügt über einen vollständigen Sicherheitsabschaltschutz bei Lichtüberlastung, Unterbrechung, Kurzschluss, Übertemperatur oder anderen Fehlern. Automatischer Neustart nach Behebung des Fehlers. Dies ist aus Sicherheitsgründen ein gelistetes Netzteil der Klasse 2 und hat Klasse II AC-Eingänge, vollständig isoliertes Gehäuse, kein Erdungskabel erforderlich. Für den Einsatz im Innen-/Außenbereich usw. an trockenen und feuchten Orten geeignet. Um ordnungsgemäß zu funktionieren, muss Ihre LED-Beleuchtung mit 12-Volt-Gleichstrom betrieben werden und gedimmt werden können. Dieser Treiber funktioniert gut mit allen 12-V-Gleichstrom-LED-Bandbeleuchtungen. Für andere Arten von LED-Beleuchtung wenden Sie sich an den Hersteller, um zu bestätigen, dass Ihre Beleuchtung dimmbar ist und mit 12-Volt-Gleichstrom betrieben wird. Ziehen Sie den Stecker des Netzkabels ab, wenn Sie einen Wechselstromdimmer verwenden. Der National Electrical Code® (NEC) verbietet das Dimmen von Leuchten, die an eine Standard-Steckdose angeschlossen sind (beachten Sie, dass dies nicht für kabellose steckbare „Lampendimmer“ gilt). Verwenden Sie die direkte Kabelinstallation mit einem AC-Dimmer oder verwenden Sie einen Niederspannungsdimmer von Armacost Lighting auf der 12-Volt-Seite

Keine Einheiten verfügbar

EAN: 0856944003962

Kategorien Werkzeuge & Heimwerken, Beleuchtung & Deckenventilatoren, Beleuchtung Zubehör, Niederspannungstransformatoren,

Für eine optimale AC-Dimmleistung verwenden Sie einen Vorwärtsphasen-CL-Dimmer oder einen gleichwertigen Dimmer. Die Verwendung von Phasenumkehr oder ELV kann die Dimmleistung beeinträchtigen. Keine Mindeststrombelastung; Das Dimmen funktioniert gleichermaßen gut, unabhängig davon, ob ein einzelnes 3-Watt-LED-Pucklicht oder ein 45-Watt-Bandlicht oder eine Kombination aus beidem betrieben wird. Schließen Sie bis zu 100 % der Nennlast von 45 Watt an – eine Leistungsreduzierung ist nicht erforderlich. Kompatibel mit SOWOHL 120-Volt-AC-Dimmern und -Lichtsteuerungen als auch mit Niederspannungs-DC-Dimmern und -Steuerungen. Bietet sanftes, flimmerfreies Dimmen über den gesamten Bereich für 12-Volt-LED-Beleuchtung wie LED-Streifen, Module, Lichtleisten, Pucks und andere LED-Leuchten.

Batteries Included?	‎No
Batteries Required?	‎No
Brand	Armacost Lighting
Capacity Description	‎45 Watt
Certification	‎UL
Color	‎White
Country of Origin	‎China
Customer Reviews	4.7 4.7 out of 5 stars 788 ratings 4.7 out of 5 stars
Included Components	‎45-Watt power supply
Is Discontinued By Manufacturer	‎No
Item Dimensions LxWxH	7 x 2.38 x 1 inches
Item model number	‎840450
Item Package Quantity	‎1
Item Weight	‎12 ounces
Manufacturer	‎Armacost Lighting
Material	‎Plastic
Maximum Frequency	60 Hz
Mounting Type	Ceiling Mount
Mounting Type	‎Ceiling Mount
Number Of Pieces	‎1
Part Number	‎840450
Pattern	‎Lighting
Plug Format	‎A- US style
Power Source	AC
Power Source	‎AC
Product Dimensions	‎7 x 2.38 x 1 inches
Shape	‎Rectangular
Size	‎45 Watt
Special Features	‎Detachable Cord
Style	‎12 Volt
Type of Bulb	‎LED
Usage	‎ETL Listed for dry and damp location use
Voltage	‎12 Volts
Warranty Description	‎Limited 3-year warranty. This product is for dry and damp locations.
Wattage	‎45 watts

5 Star

4 Star

3 Star

2 Star

1 Star

Schreiben Sie eine Bewertung

Ihre E-Mail wird nicht veröffentlicht. Alle Pflichtfelder sind mit gekennzeichnet^*

Deine Bewertung

Scritto da: Thomas H.

Had to replace a unit in the kitchen, and this works perfectly

My under cabinet lights stopped working. Changed the dimmer switches, but it finally was the transformer. All good now.

Scritto da: PVM

Does what it's supposed to

Easy installation. I wired directly to a dimmer switch and it works perfectly.

Scritto da: S.C. Fluhr

Smooth dimming led driver

Quality made, nice and compact, works as advertised

Scritto da: paul

Electrician approved

One of the few LED drivers that can be dimmed in compliance with the NEC for electrical inspection. The cord that came with it can be unscrewed and the driver can be hardwired with 14-2 romex. The connections are circuit board terminal blocks on each end, so they required a jeweler screwdriver. Be sure to hold the blocks when tightening the screws, so the block doesn't torque off the circuit board. The unit does soft start and ramp to full in 1 sec. Other than that, there isn't a 3 sec delay to warm up like cheap switching power supplies have before they instantly pop on at full brightness. That's nice. I had no problem using a z-wave smart dimmer. I used the a Linear aka Nortek aka GoControl model WD500Z5 zwave dimmer and it successfully burned in so far for 1 day. It does get very warm, even pushing only 10 watts. Like a hot McDs coffee cup hot. Not too hot to start papers on fire, but too warm to be comfortable holding. Plan for that when mounting. Also, If you wired several LED homeruns instead of daisy chaining the runs, be sure to plan on wirenuts or a terminal block to connect to the driver- it only has internal room for 1 #12 pair of wires. You have no internal room for other connections. I powered 10 watts of LED under cabinet LED tape. The cables in the pic are 14-2 romex and 16-2 cl2 riser cable. No issues with those gauges.

Scritto da: Snap, Crackle and Pop

A high-quality dimmable, "universal" 120V to 12V DC LED driver power supply

The Armacost Lighting 840600 is a high quality, dimmable power supply for 12V LED fixtures or systems. COMPATIBILITY: This power supply should be compatible with a wide range of 120V dimmers. The installation instructions state the following: "Armacost Dimming LED Drivers are compatible with both forward phase (leading edge, triac, incandescent) and reverse phase (electronic low-voltage, ELV, and trailing edge) AC dimmers ... They are also compatible with low-voltage PWM dimmers and RGB color controllers. "Although virtually all dimmers will work with Armacost Dimmable LED Drivers, Armacost Lighting recommends dimmers that can be programmed or have an adjustment dial to set the low end dimming range." BUILT IN CONNECTORS: The built in connectors work well and quickly. They need to have some of the outer insulation to clamp onto, to keep the stress of any pull on the wire from going to the terminal connection itself. So don't strip too much of the inner or outer insulation. LOW MINIMUM POWER LOAD: The minimum power load is just 5 watts. VOLTAGE: Output is 12V DC. DIMENSIONS: It's somewhat large, at 7-1/16 inches long by 2-3/8 inches wide by 1-3/8 inches high. ENCLOSURES: If you want an enclosure, Armacost makes variations with enclosures for conduit connections. The only real negative is the cost, though of course having a high-performing, high quality power supply makes it a reasonable value. Lower-watt drivers are less expensive than this one. The manufacturer's website has lots more info, including specs and installation instruction. TWO WARNINGS: First, be sure to get a power supply rated with enough watts to cover your needs. Second, be careful to get a power supply with the right input voltage. Armacost makes a line of 12V dimmers and matching power supplies. This product is the universal power supply, to be used with a range of dimmers and 120V.

Scritto da: CAMPFIRESKY

NEW KITCHEN SINK LIGHTING

Very easy to install. I hard wired the power pack and also installed a dimmer switch. Works perfectly with no humming. Great product.

Scritto da: Kindle Customer

Everything I wanted at a reasonable price

Put in a dimmer switch and get the 120 leds per meter. You can crank it up to give all the light you will ever need and yet dim it down to simply add ambience to your kitchen. I installed them in the channel with the diffusers and absolutely love them.

Scritto da: Nick

It actually works with a dimmer!!

Wow an LED driver / power supply that actually dims the LEDs!!! I thought there was something wrong with my LEDs or dimmer as I tried two different PLUSPOE dimmers that did not actually dim anything and also buzzed. This driver actually works, and works well. I am using the 12v/24watt one to drive 8x half moon 12v LED stair lights. I am also using a Leviton 6674 dimmer in the wall. There is no switching noise from this driver, the construction is solid and the dimming is smooth without flicker. Completely worth the higher price than non certified drivers. The only thing that was odd is that it did not come with a power cord. The lack of a power cord was not a big deal as I had one laying around, but I could see it bothering other people. I have a light switch controlling half of a receptacle in low voltage box, so I did need one.