Arnold (490-325-0012) Roue avant pour tondeuse à gazon 15" Ajustement universel, 15

Brand:Arnold

3.5/5

€
121.67

Si vous voulez que votre équipement électrique extérieur dure plus longtemps et en fasse plus, vous avez besoin de pièces, d'accessoires et d'accessoires Arnold. En vous offrant une grande variété de produits de qualité supérieure sans tracas, les pièces Arnold garderont tout votre équipement dans le meilleur état possible. Compatible avec des tonnes de grandes marques, plus de 50 ans de performances éprouvées ont valu à Arnold une réputation d'innovations de produits de pointe et une vaste expertise en ingénierie. De l'entretien de base aux innovations majeures, Arnold a tout ce dont vous avez besoin pour que votre équipement continue de fonctionner comme il se doit saison après saison. Avec Arnold, vous pouvez être sûr d'un produit fiable avec un ajustement, une conception, un matériau et une construction précis. En plus des pièces et accessoires fiables, les instructions faciles à suivre et les conseils supplémentaires d'Arnold faciliteront l'entretien de votre équipement et vous assureront que le travail est bien fait.

Aucune unité disponible

EAN: 0037049944170

Catégories Patio, Lawn & Garden, Outils électriques extérieurs, Pièces de rechange et accessoires, Pièces détachées et accessoires pour tondeuses à gazon, Pièces de rechange pour tondeuses à gazon,

INCLUS : Le contenu comprend une roue avant avec jante et des essieux de 3/4 po de diamètre. Pour des instructions d'installation détaillées, veuillez vous référer à votre manuel d'instructions. Gonflez correctement : les pneus correctement gonflés durent plus longtemps, offrent une meilleure traction et aident à couper à niveau Remplacez votre pneu s'il y a des dommages et une usure visible des pneus ou si le pneu perd de la pression d'air. Remplacement : remplacez les roues plates ou usées de la tondeuse à gazon chaque saison pour garder votre machine correctement entretenue. La bande de roulement Turf Saver offre une excellente traction sur le gazon et l'herbe. Polyvalent : s'adapte à la plupart mais pas à tous les Ariens, Craftsman, Cub Cadet, Husqvarna, John Deere, Poulan, Poulan Pro, Troy-Bilt et la plupart des tracteurs de pelouse avec une roue avant de 38,1 x 15,2 cm avec axe de 3/4". Le pneu a une capacité de charge de 300 lb, une bande de roulement anti-gazon, un roulement en nylon et une cote à 2 plis. Compatibilité : ensemble de roue avant universel de 38,1 x 15,2 cm pour tracteurs de pelouse Troy-Bilt, Craftsman et John Deere avec essieux de 1,9 cm, remplace M123810, GY20638, 634-05067. Pièce universelle pour les roues commençant par 532106108, 532122073, M123810, GY20638, 634-05067, 734-0731 et 634-05066.

Brand	Arnold
Country of Origin	USA
Customer Reviews	4.5 4.5 out of 5 stars 1,485 ratings 4.5 out of 5 stars
Exterior Finish	Machined
Is Discontinued By Manufacturer	No
Item Diameter	15 Inches
Item Weight	7.85 Pounds
Manufacturer	Arnold
Material	Nylon
Product Dimensions	15 x 15 x 6.5 inches
Rim Size	15 Inches
Rim Width	6 Inches
Size	15"
Vehicle Service Type	Mower
Wheel Backspacing	3.5 Inches
Wheel Size	15 Inches

5 Star

4 Star

3 Star

2 Star

1 Star

Donnez votre avis

Votre courriel ne sera pas publié. Tous les champs obligatoires sont marqués d'un^*

Votre note

Scritto da: B R

Changed my life!!!

This tire changed my life. Previously, I’ve been dragging my riding lawnmower around with a rope. Then somebody pointed out I could put tires on it! I didn’t believe this to be so, but I ordered tires from Amazon and it was incredible! I highly recommend these tires.

Scritto da: mcg 79

Fit cub cadet lt1046

Seems like this was just what I needed

Scritto da: Philip Byrd

Easy to mount.

It was the right fit.Easy to mount.

Scritto da: CoolBoomer

Nice Wheels & Tires Took 10 Minutes to Change

These came with a set of bushings and a spacer for each wheel so that they fit the two common different size spindles. The bushings are some sort of man-made material (nylon?) and the inboard ones have a grease fitting built into them. Another review mentioned putting the grease fitting on the outboard side--*no way*--the directions show the fitting side facing the mower not the outside. You still need to put on your outer washers, C-clip and dust cap. These came pre-inflated and look like good tires, every bit as good as the ones that came on my Murray tractor. Why mess with getting the inner tubes replaced and all when you can just pop these out of the box, swap them and be done with it. Hope this review was helpful.

Scritto da: J. Fox

Look good, but not a fit for all mowers mentioned

The tire arrived fully inflated and looks good. The install was relatively painless. However, these wheels are not to OEM spec for my mower, a 2012 LTX 4200 Cub Cadet, even though the description stated they are. The original Cub Cadet wheels have a deeper cylinder for the grease fittings and bushings. The result with the new wheel is that it cannot hold the grease fitting in place for long, even after I've hammered it in with a rubber mallet and added the C-clip. The grease fitting will come out of the cylinder in the middle of the wheel after driving about 50 feet. The result after the grease fitting comes out is a constant, annoying swealing. It also does not stay inflated for a reason I have yet to discover. MAKE SURE THIS WHEEL IS AN EXACT MATCH TO YOUR MOWER AND OEM NUMBER.

Scritto da: Franky Lynn

Very good "high flotation" wheel and tire update.

Very good "high flotation" wheel and tire. I honestly think this wheel and tire combo is almost overbuilt for anything a person might use it for. The tire is big and soft, yet holds air indefinitely. I need something to hoist a standby motor generator that weighs over 200 pounds, as well as other heavy items, so I am building an all electric "mobile derrick" which will have a tiltable A-frame, a tiltable boom on top of that, and a winch with 1800 pound rated cable for lifting things. This "mobile derrick" will be using the three Arnold 15-inch Lawnmower wheels that I have purchased. The tires are big enough to give my "mobile derrick" the ability to traverse soft ground. This wheel/tire combo does not come with any ball bearings, just cheap plastic bushings, one of which has a grease zerk molded into it for pumping grease inside the wheel hub. The Arnold wheel/tire combo is very heavy duty and well built, so if your wheel uses 3/4" O.D. bearings and they are still serviceable, then this wheel will probably work. In my application mentioned above, I am going to permanently mount the wheel onto 3/4" axles, and the axles will rotate on pillow bearings.

Scritto da: MnW

bushings wear out too fast

the bushings wear out very fast on these but our local people stopped selling them. they're more expensive than they should be but install fairly easily.

Scritto da: Draco76123

Perfect fit

Just bought a used Craftsman YT3000. Previous owner replaced one of the wheels with one that was a little thinner and not fitting the axle well so it wiggled around alot. This was a near perfect replacement. It matched the original perfectly and fit snug on the axle with the included spacers. The axle inserts are plastic with built in plastic grease fitting, took me a minute to figure out it was a grease fitting since I've never seen a plastic one before, but I won't remove a star for it. It took me less than 5 minutes to swap it out with the old one. Only time will tell regarding durability, I'm guessing the axle inserts aren't going to last nearly as long as metal ones, but we'll see, it could surprise me.

Scritto da: Shawn R

Very Impressed!

Was pleasantly surprised that the tires on these were the same as the originals on my garden tractor., Carlisle Turf- Saver. These come with plastic bushings instead of the original metal ones, so I am a little concerned about their longevity, but we'll see what they look like after a full season. The outside diameter of the hub is smaller than the original, so my original dust covers were too big. I was able to make the old ones work, at least temporarily, but will probably have to get proper ones at some point.

Scritto da: MJB Ontario

Good Quality

Just need to check the axel size will not work on 5/8 inch axel and does not include an adapter for that size.

Scritto da: Rod

Works

cannot grease it and cannot install cap.

Scritto da: Cam

poor quality

These wheels have cheap plastic bushings instead of bearings. I don't recommend.