Penn F93 Serie Loftvolumen Kontroll fir Deep Wells, mécht op Drockfall, Kee Gage Tap, Keen Drockausléisungsventil F93A-1C

Name: Penn F93 Serie Loftvolumen Kontroll fir Deep Wells, mécht op Drockfall, Kee Gage Tap, Keen Drockausléisungsventil F93A-1C
Brand: Johnson Controls
Price: 123.04 EUR
Availability: InStock

Brand:Johnson Controls

3.7/5

€
123.04

D'F93 Serie Air Volume Controls fir Deep Wells kontrolléiert d'Quantitéit u Loft an de Wunnwaasserspäicherbehälter vun Deep Wells Systemer. Déif Wells si méi wéi 25 ft (7,6 m) déif. F93 Serie Kontrollen automatesch Loftvolumen an de Stockage Panzer vun déif gutt Waasser Systemer behalen, andeems d'Loft aus dem Tank an d'Ëmgéigend Raum flücht, wann de Waasserniveau am Tank fällt (Erhéijung vum Loftvolumen). F93 déif gutt Kontrollen oppen der Loft Krunn op engem Fall am Tank Waasser Niveau bluddeg iwwerschësseg Loft aus dem Tank bei Drock bis zu 100 psig (690 kPa). De F93H huet e Minimum Drock Release Ventil fir den Tankdrock ënner 25 psig (172 kPa) ze reduzéieren. Benotzt dëse Modell op Uwendungen wou Waasser séier drainéiert ka ginn. Kuckt d'F93 Serie Air Volume Kontrollen fir Deep Wells Product Bulletin (Deel Nr. 24-7664-3000) fir wichteg Produktapplikatiounsinformatioun.

Betrag

An de Weenche leeën Kaaf elo

EAN:

Kategorien Tools & Home Verbesserung, Industriell & Wëssenschaftlech, Gebai Ëmgeréits, HVAC, HVAC Kontrollen,

robust Noryl (héich performant thermoplastesch) Kierper widderstoen mechanesch Schued a corrosion.

Country of Origin	USA
Item model number	F93A-1C
Manufacturer	Johnson Controls, Inc
Package Dimensions	10.2 x 3.94 x 1.73 inches; 7.05 Ounces

5 Star

4 Star

3 Star

2 Star

1 Star

Schreift Är Bewäertung

Är E-Mail gëtt net publizéiert. All obligatoresch Felder sinn markéiert mat^*

Är Bewäertung

Scritto da: JS

Water tank switch

Fit great no issues

Scritto da: Beaty Wade Tharp

Fine valve

This style of valve is just fine for its function. My only wish is some ingenious engineer would figure out a way for the air vent portion of the valve to not get plugged up. I.e. some sort of wiper assembly that cleans off the air vent port as the float cycles up/down.

Scritto da: JERED ECKLE

Works like a champ!

Replaced one just like it in style. Immediately started working like it should after a few drain & fills of the tank!

Scritto da: MnBoy

It works.

Turned power off to deep well. Drained the water from the existing metal water tank through faucets. Waited until all the water... then air... left the tank. Closed the faucets. Took the old volume control out and put the new one in. This was a fairly easy procedure. Turned power on and waited for tank to fill. I could hear the air escaping the valve, which I did not hear on the old valve. The tank filled properly and I turned the faucets on to bleed air from lines. Pump runs only a fraction of what it did prior to new valve installation. I think the price is a bit high, but if it helps the pump by running less it is probably worth it.

Scritto da: Patrick

Identical to original.

Works fine but the arms on these floats are not a solid rod and that is what went bad on my old one. The arm bend up . These look identical to my original so i decided to beef up the rod with a piece of 8 awg solid copper wire soldered to the float arm. If not for the weak float arm this device would probably never fail.

Scritto da: Quail Valley Farm

Can't go wrong with Johnson Controls components

This switch closes the air pressure relief valve when the water level in the tank reaches the appropriate level. The switch was failing and dripping water in the pump house, non-stop. This is the exact same brand/model I replaced, and the one that failed was on the tank when I purchased the property in 2003, demonstrating its longevity. Given this is a farm tank, serving a home with a pool, and the property, it gets a significant workout. I suspect that because the well is inside of a structure, this switch and other components last somewhat longer than they would if the well system was exposed to the elements.

Scritto da: Mark Williamson

Says Penn, not Johnson controls.

Using it as a spare, not installed yet.

Scritto da: Roark

Works very well and has “secret” ability. :)

Perfect replacement for my deep-well system. Something not mentioned in the description is this has an *optional* outlet for gauge/pressure switch that is pre-threaded. If you dont need this feature, simply do nothing. This threaded recess does NOT by default connect to the tank-side pressure. If you want this feature, simply drill a small (tiny is fine!) hole in the threaded recess and screw your gauge or pressure switch in. That little hole connects the gauge to the pressure side of things. This means one unit can fill the role of two. Simply drill the hole to allow connection of a pressure switch or gauge. Neat!