CURT 23527 Ensemble de verrous de remorque pour récepteur 2 pouces, portée de loquet de coupleur 2-1/2 pouces

Brand:CURT

3.2/5

€
72.33

ÉTANCHE. Les composants internes du verrou d'attelage et du verrou d'attelage de remorque peuvent être facilement protégés des éléments grâce aux capuchons anti-poussière étanches inclus. PRATIQUE. Les verrous de remorque de cet ensemble disposent d'une simple activation de verrouillage 1/4 de tour pour un verrouillage et un déverrouillage rapides selon les besoins. Les serrures sont également identiques pour un accès pratique à une seule clé (quatre clés incluses). POLYVALENT. Avec une goupille de 5/8 pouces de diamètre, le verrou d'attelage du récepteur s'adapte à pratiquement n'importe quel récepteur d'attelage de 2 pouces avec un trou de 5/8 pouces. Le verrou de verrouillage du coupleur a une goupille de 1/4" et s'adapte à une portée de coupleur jusqu'à 2 1/2". FORCE FIABLE. Pour protéger votre équipement contre le vol et vous donner la tranquillité d'esprit, le verrou d'attelage et le verrou d'attelage de remorque sont fabriqués avec une construction en acier à haute résistance. SÉCURITÉ COMPLÈTE. Cet ensemble de serrures de remorque offre une sécurité complète de votre système de remorquage. Il comprend un verrou d'attelage de remorque pour verrouiller un support à boule ou un autre accessoire d'attelage de récepteur, ainsi qu'un verrou d'attelage pour sécuriser votre attelage de remorque.

Montant

Ajouter au panier Acheter maintenant

EAN: 0612314235278

Catégories Automobile, Accessoires extérieurs, Produits de remorquage et treuils, Accrochements Accessoires, Câblage,

Brand	CURT
Brand	‎CURT
Country of Origin	‎USA
Customer Reviews	4.2 4.2 out of 5 stars 103 ratings 4.2 out of 5 stars
Exterior	‎Chrome
Finish Type	Chrome
Is Discontinued By Manufacturer	‎No
Item model number	‎23527
Item Weight	‎13.7 ounces
Manufacturer	‎CURT
Manufacturer Part Number	‎23527
Material	Carbon Steel
Model	‎23527
OEM Part Number	‎23527
Product Dimensions	‎8.75 x 2.88 x 1 inches
Vehicle Service Type	Marine-Personal-Craft, ATV, Trailer

5 Star

4 Star

3 Star

2 Star

1 Star

Donnez votre avis

Votre courriel ne sera pas publié. Tous les champs obligatoires sont marqués d'un^*

Votre note

Scritto da: Arturo Figueroa

Trailer lock set

This is a great purchase, have one key for the two locks is great. They seem to be well made.

Scritto da: Stephen Champion

Too short for Tacoma factory hitch

Not my favorite. The no go problem is that the receiver lock is too short to fit on my Tacoma. The information in the product listing only provides overall length, not usable length, so I couldn't *know* it would fit prior to purchasing. The coupler lock was *exactly* the right length for the bulldog coupler on my 7000# auto hauler. Unfortunately, the lock and barbell are a smidge to short to engage on my Toyota OEM 2" receiver. Even if it fit my truck, I would still look for a different set. The locks I currently use (from different manufacturers) are spring loaded, so I only use the key to unlock - I snap the lock onto the shaft, pull to test it, and off we go. On these Curt barbell type locks without the spring latch. you have to both hold the lock shaft in place and keep the lock from spinning while turning the key to engage the lock. My test fitting with these Curt locks made me realize the value of the spring latch.| The retainer for the rubber cover came off when I pulled the cover off. I can see that being very annoying if I actually used these. Not a terrible product in my limited experience, not one I would recommend.

Scritto da: Samuel

Love CURT trailer parts

I have been using CURT trailer parts for years now! i normally get the barbed tongue lock but it has gotten bent the last 2 times then hangs up. So this time i went with the heavier duty solid shaft. It has everything i wanted but sadly the lock on the 3rd connect stuck. I played with the lock and got the key out, tested pulling on the lock 2 or 3 times. then drive for 1 hr to my customer and when i got to the back of the truck the lock and shaft were gone. I am probably a fluke but be weary of the lock. that has always been my worry the rubber covers always wear out first then the locks gum up shortly after

Scritto da: Melek

I am so pleased with these locks.

At first, I didn't think it would fit the pin side of my camper. It looked too big, but it slipped in without trouble. I do agree with others about it being difficult to lock and unlock, because the locking mechanism spins with the rod, but with a little practice-it will be second nature. The sturdiness and slim features combined will hopefully help keep it safe from thieves. There's very little space on the outside for a hammer or clamp to wrench off. I am glad I bought this locking system. Great value for the money, too!

Scritto da: Nick Plaskon

Seems Pretty Good

So far so good. Items arrived on time, in new condition. The smaller pin is way longer than necessary, the larger one works fine & is long enough for a Class I or Class II hitch (1-1/4" square receiver opening). Turn the key clockwise to unlock, which seems counter-intuitive to me. I like the convenience of the locks being keyed-alike. Im satisfied with this purchase.

Scritto da: Joebackman1

Purchased product because it claimed origin of product USA but is actually made in China

Would not recommend. Should have known as soon as I received product the plating on the locks looked very cheap. Typical China grade. Won't be buying Curt products again. Junk.

Scritto da: Curtis C.

Garbage!

Buyer beware. These locks are junk. Lock will not work after 2 months. Cheap crap!

Scritto da: GK

Requires modification to fit 2010 Tundra Hitch, but nicely made.

Was a little too skinny for my 2010 Tundra on the hitch side. I ground it down and made it work. Nicely made, good quality, good value. They provide a bunch of keys too, which is nice.

Scritto da: Leonard Hutchins

Good stuff

Works great

Scritto da: Eric

Not built for Canadian Winters

Not built to handle Canadian Winters. Road salt killed this lock in only 4 months of use. My old Master brand hitch lock made it 4+ winters and still worked good (it also rusted up and looked bad, but never left me locked out like this one did). “Durable Chrome-plated finish” is not an accurate description.